Global-machinery-company SYT210 Bedienungsanleitung

1210MM (8 1⁄4”) SLIDE COMPOUND MITRE SAWWITH REDEYE® SYT210INSTRUCTION MANUALBlackCyanMagentaYellowCode: SYT210Date: 061010 Edition: 06 Op: PW

10the mitre table to the desired position. The mitre table features positive click stops for quick setting of common mitre angles.WARNING. Be sure to

114. Rotate the table (16) until the pointer is positioned at 0º.5. Tighten the mitre locks (18).6. Loosen the bevel lock (12) and set the saw arm (5

1210. Loosen the Phillips head screw holding the pointer of the mitre scale (17) and adjust it so that it accurately indicates the zero position on th

1313. Depress the spindle lock button (25) and replace the the flat washer and blade bolt.14. Use the hex key to tighten the blade bolt securely (tigh

143. Press the release latch (24) (fig. k) and slowly lower the blade into the workpiece (fig. l) and slide it away from you at the same time until

152. Loosen the mitre locks (18). 3. Rotate the mitre table (16) until the pointer aligns with the desired angle on the mitre scale (17).4. Retighten

16MaintenanceWARNING. Always ensure that the tool is switched off and the plug is removed from the power point before making and adjustments or mainte

17

18

19

2ContentsWarranty 2Introduction 3Environmental protection 3Description of symbols 3Specifications 3Safety rules for laser lights 4General safety

GMC customer assistIf your product needs repairing, replacing, technical service or you simply need help or advice, please contact us on our Customer

3Description of symbolsThe rating plate on your tool may show symbols. These represent important information about the product or instructions on it

4Safety rules for laser lightsThe laser light/laser radiation used in the GMC Redeye® system is Class 2 with maximum 1mW and 650nm wavelengths. These

5but only once it has been removed from the mains power and secured in the locked down position.• Do not use the saw without the guards in position,

615. Avoid unintentional starting. Always check that the switch is in the OFF position before plugging in the tool to the power supply. Do not carry a

7• Avoid cutting nails. Inspect the workpiece and remove all nails and other foreign objects before beginning sawing.• Support the work properly.•

8Know your productBefore using the saw, familiarise yourself with all the operating features and safety requirements.1. Laser light assembly2. Laser

9UnpackingDue to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anything