1710WSCROLLING PENDULUM ACTION JIGSAW SPJ2HMINSTRUCTION MANUALBlackCyanMagentaYellowCode: SPJ2HM IMDate: 070207 Edition: 12 Op: AB
10Position 1. LOW – Minimal pendulum action for cutting most metal.Position 2. MEDIUM – Medium pendulum action for cutting plastics, and hardwoods.P
11Note. For accurate work it is necessary to do a practise cut first. Check the cut and reset the angle until the correct cut is achieved.Variable spe
12Combined laser light/ LED switchThis jigsaw is fitted with two forms of lighting to assist in maintaining accurate alignment with the cut line.Both
13Switch on the jigsaw and allow the blade to reach maximum speed.Slowly guide the jigsaw forward, building up speed as you go, with one hand on the h
14Parallel cutsNote. Parallel cuts can be achieved using the parallel guide (20) (fig g). or by clamping a straight edge to your workpiece (fig h).Fit
GMC customer assistIf your product needs repairing, replacing, technical service or you simply need help or advice, please contact us on our Customer
2ContentsWarranty Power ToolsWhilst every effort is made to ensure your complete satisfaction with this tool, occasionally, due to the mass manufactur
3Description of symbolsThe rating plate on your tool may show symbols. These represent important information about the product or instructions on it
4Safety rules for laser lightsThe laser light/laser radiation used in the GMC REDEYE® system is Class 2 with maximum 1mW power and 650nm wavelength. T
5e. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of e
6than that specified for the tool can result in serious injury to the user, as well as damage to the tool. If in doubt, do not plug in the tool. Using
7Know your product1. Trigger switch2. On / off switch3. Lock-on button4. Scrolling control knob5. Pendulum lever (scrolling lock)6. Blade guard7. Blad
8Trigger switchNote. The trigger switch is only used in the conventional jigsaw mode, when the removable handle is fitted.Pull up on the trigger switc
92. With a blade fitted move the variable speed dial (8) to number 3 (low speed).3. Apply pressure to the front of the anti splinter guard on the ed
Kommentare zu diesen Handbüchern