• Melbourne • Perth • Auckland • Hong Kong • Shanghai • Taipei • New York • Verona • London • ParisINSTRUCTION MANUALLS211050408 ED6 PR210mm (8 1/4”)
10A1UnpackingDue to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anythi
11Mitre table locksThe mitre table locks (15) are used to lock the table at the desired mitre angle (fig. D). The mitre saw cuts from 0° to 45° both l
123. Loosen the mitre locks (15).4. Rotate the table (12) until the pointer is positioned at 0º.5. Tighten the mitre locks (15).6. Loosen the bevel lo
1310. Loosen the Phillips head screw holding the pointer of the mitre scale (13) and adjust it so that it accurately indicates the zero position on th
14that the inner blade washer sits behind the blade (fig. W).CAUTION. To ensure correct blade rotation, always install the blade with the blade teeth
151. Pull on the release knob (2) and lift the saw arm to its full height.2. Loosen the mitre locks (15).3. Rotate the mitre table (12) until the po
16Adjusting the laser lineThe laser is factory set to emit a laser line along the middle of the blade. To adjust the position of the laser, proceed as
17MaintenanceWARNING. Always ensure that the tool is switched off and the plug is removed from the power point before making and adjustments or mainte
19
ContentsFull 2 Years Home Use WarrantyWhilst every effort is made to ensure your complete satisfaction with this tool, occasionally, due to the mass m
Carefully read the entire Instruction Manual before using this product.Before returning this product for a Warranty Claim or any other reason Please C
Dear CustomerIf you require any help with your product, whether it is a Warranty claim, spare part or user information, please phone our Help Line for
4Safety rules for laser lightsThe laser light/laser radiation used in the GMC Redeye® system is Class 2 with maximum 1mW and 650nm wavelengths. These
5• The mitre saw can be safely carried by the main handle but only once it has been removed from the mains power and secured in the locked down posit
613. Disconnect idle tools. Switch off the power and disconnect the plug from the power point before servicing, when changing accessories and when the
7• Never use your hands to remove sawdust, chips or waste close by the blade.• Use only blades as recommended by the manufacturer and which conform
8AccessoriesThe GMC LS211 Compound Mitre Saw is supplied with the following accessories as standard:• Saw blade (fiited)• 6mm Hex Key • Instruction
9Know your productBefore using the saw, familiarise yourself with all the operating features and safety requirements.1. Saw arm2. Release knob3. Op
Kommentare zu diesen Handbüchern